| 1. Lift the car on the elevator. |
| 2. For access to the transmission remove the lower mudguard. |
| 3. Install the selector lever in situation P. |
| 4. Carefully wipe the pallet of the automatic transmission. |
| 5. Install the corresponding container under a drain stopper of the transmission, then unscrew a drain stopper and after running off of oil screw up a drain stopper on the place (see rice. Unscrewing of a stopper of discharge of oil from the automatic transmission). |
| 6. For a bolt of fastening of a pulley of a bent shaft turn a bent shaft of the engine in such situation until the drain stopper of the hydrotransformer is seen through an opening in a transmission case (see rice. An arrangement of a stopper of discharge of oil from the hydrotransformer). |
| 7. Install the corresponding container under a drain stopper of a hydrotransform a Torah and unscrew a drain stopper. After full discharge of liquid from a hydrotrance of a formator establish a drain stopper into place. |
| 8. Unscrew bolts of fastening of the pallet, then remove tightening levels and lower the pallet from the transmission (see rice. Arrangement of bolts of fastening of the pallet of the automatic transmission). Remove rubber laying. |
| 9. Unscrew screws and remove the mesh filter (see rice. Removal of the mesh filter). |
| 10. Clear the internal surface of the pallet of the automatic transmission. |
| 11. Install the new mesh filter and fix by screws. |
| 12. Install the pallet and tightening levels and fix the pallet by bolts, having tightened them the required moment. |
| 13. In the presence establish a mudguard. |
| 14. Lower the car on the earth, then release the lock lever and take the probe for measurement of level of oil in the automatic transmission. |
| 15. Through a pipe for the probe of measurement of level of oil fill in 4 liters of the required liquid in the transmission. Start the engine in the idling mode with the selector lever in situation P. |
| 16. Continue to add gradually liquid until its level is established 12 mm below than min tag on the probe for measurement of level of oil. |
| 17. Move the selector lever to all provisions, detaining him in each situation for several seconds, then return the selector lever to situation P. |
| 18. Repeatedly check liquid level in the automatic transmission. |
| 19. Repeatedly add liquid min up to one level of 12 mm lower than a tag and move the selector lever to all provisions, then establish in situation P. Repeat this operation until liquid level in the transmission does not remain to constants. |
| 20. Carry out a short trip and repeatedly measure liquid level in the automatic transmission. |