1. Remove the air filter. Check that the lever of a butterfly valve of the carburetor is located opposite to the screw of adjustment of turns of idling. Otherwise perform the following operations (see rice. Adjustment of length of a cable of management of pressure on models with the carburetor):
– start the engine;
– press a vacuum hose of the executive mechanism of a butterfly valve, at the same time the lever of a butterfly valve has to be installed opposite to the screw of adjustment of turns of idling;
– switch off the engine. |
| 2. Remove a cable of management of pressure from the spherical hinge on draft of a butterfly valve. |
| 3. Move a cable to a cable cover, then extend it from a cover before emergence of notable resistance. |
| 4. Enshrine it in this provision of a cable on the spherical hinge of draft of a butterfly valve. If cable length too big or too small, rotating the regulator on a cable cover, establish the required cable length (see rice. Removal of a cable from the spherical hinge). |
| 5. After carrying out adjustment install the air filter. |