20.5. Adjustment of a cable of management of pressure

Models with the carburetor


Adjustment of length of a cable of management of pressure on models with the carburetor

A – lever of a butterfly valve;

B – screw of adjustment of turns of idling;

C – vacuum hose

Removal of a cable from the spherical hinge

Remove the end of a cable (1) from the spherical hinge (2), then press it into a cover and take again. If necessary adjust cable length, rotating the regulator on a cover of a cable (3) (carburetor models).


PERFORMANCE ORDER
1. Remove the air filter. Check that the lever of a butterfly valve of the carburetor is located opposite to the screw of adjustment of turns of idling. Otherwise perform the following operations (see rice. Adjustment of length of a cable of management of pressure on models with the carburetor):
– start the engine;
– press a vacuum hose of the executive mechanism of a butterfly valve, at the same time the lever of a butterfly valve has to be installed opposite to the screw of adjustment of turns of idling;
– switch off the engine.
2. Remove a cable of management of pressure from the spherical hinge on draft of a butterfly valve.
3. Move a cable to a cable cover, then extend it from a cover before emergence of notable resistance.
4. Enshrine it in this provision of a cable on the spherical hinge of draft of a butterfly valve. If cable length too big or too small, rotating the regulator on a cable cover, establish the required cable length (see rice. Removal of a cable from the spherical hinge).
5. After carrying out adjustment install the air filter.