16.4. Ignition coil

SYSTEM OF IGNITION EZL

Removal

Removal of a plastic casing from the ignition coil

Places of connection of wires to the ignition coil
A – place of connection of the central high-voltage wire;

B – the place of connection of wires to primary winding of the coil of ignition


Arrangement of coils of ignition on models with a control system of the HFM engine
A – ignition coils;

B – protection cover


PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. On all models the coil of ignition is installed on an arm in the left forward part of a motor compartment. Release clamps and remove a plastic casing from the top part of the coil of ignition (see rice. Removal of a plastic casing from the ignition coil).
3. Disconnect the central high-voltage wire from the central contact of the coil of ignition (see rice. Places of connection of wires to the ignition coil).
4. Unscrew nuts and disconnect positive and negative wires from plugs of primary winding of the coil of ignition. Before removal mark wires.
5. Unscrew bolts and remove the ignition coil.

Installation

PERFORMANCE ORDER
1. Installation is made in the sequence, the return to removal.

MODELS WITH THE CONTROL SYSTEM OF THE HFM ENGINE

Removal

Arrangement of coils of ignition and their connection with cylinders which serve them
A – cylinders No. 2 and 5;

B – cylinders No. 3 and 4;

C – cylinders No. 1 and 6;

D – to the ECU block from cylinders 1 - 6


PERFORMANCE ORDER
1. Three coils of ignition are installed on a cover of a head of the block of cylinders under a casing. In their drawing Arrangement of Coils of Ignition and Connection with cylinders which serve them the arrangement of coils of ignition and cylinders which they serve is shown.
2. Remove a weight wire from the accumulator.
3. Unscrew screws and uncover, closing ignition coils. Disconnect high-voltage wires and wires of primary windings from ignition coils.
4. Unscrew screws and lift the ignition coil from a cover of a head of the block of cylinders, at the same time disconnecting a high-voltage wire from a spark plug.

Installation

PERFORMANCE ORDER
1. Installation is made in the sequence, the return to removal.