19.3. Replacement of oil in the transmission
Prevention
For unscrewing of a stopper of filling / check of level of oil and a stopper of discharge of oil it is necessary to use a six-sided key.
Unscrewing of a stopper of filling / check of level of oil in the mechanical transmission
Arrangement of a stopper of discharge of oil from the mechanical transmission
| PERFORMANCE ORDER |
| 1. Install a suitable container under the stopper of discharge of oil from the transmission located in the lower part of a case of the transmission. For acceleration of discharge of oil from the transmission on the right side unscrew a stopper of check of level / filling of oil. Unscrew a stopper of discharge of oil from the transmission and if it is necessary, press a stopper when you unscrew that oil did not proceed prematurely. Unscrewing of traffic jams requires use of a hexagon, but instead of it it is possible to use the corresponding extended nut or a piece of a hexagon and a wrench (see rice. Unscrewing of a stopper of filling / check of level of oil in the mechanical transmission, the Arrangement of a stopper of discharge of oil from the mechanical transmission). |
| 2. When oil completely flows down, wipe everything around a drain opening a rag and reliably screw up a stopper with a new sealing ring into place. |
| 3. Fill in in the transmission oil of the required type to the lower level of a jellied opening. A finger check whether reaches the level of oil of edge of an opening and, if necessary, add oil. When filling oil substitute capacity for collecting the following oil. Do not fill in too much oil at one time. |
| 4. Screw up a stopper of filling and check of level of oil. |
|