22.21.1.4. Sensor of a back wheel
Prevention
At installation of the sensor it is necessary to use a new bolt of fastening.
Arrangement of the sensor of a back wheel on a case of reverse main gear
| PERFORMANCE ORDER |
| 1. Lift a back part of the car and record on supports. |
| 2. For improvement of access to the electric socket of the sensor remove back sitting. |
| 3. Check that ignition is switched off, then disconnect the electric socket of the sensor from a plait of wires. Exempt a sensor electrical wiring from fastening brackets in order that it could be removed together with the sensor. |
| 4. Working under the car, take a sensor electrical wiring from the brackets fixing it to the car bottom. |
| 5. Unscrew a bolt of fastening and remove the sensor with a sealing ring from a case of reverse main gear (see the drawing). Check a condition of a sealing ring of the sensor and, if necessary, replace it. At installation of the sensor it is necessary to use a new bolt of fastening. |
|
Installation
| PERFORMANCE ORDER |
| 1. Clear the interfaced surfaces of the sensor and a case of reverse main gear and establish a new sealing ring of the sensor. |
| 2. Install the sensor into place and fix it by a new bolt, having tightened it the required moment. |
| 3. Pass the electric socket of the sensor through rubber consolidation throughout the car bottom, then in interior of the car connect the electric socket to the main plait of wires. Fix by brackets a sensor electrical wiring. |
| 4. Establish back sitting and lower the car. |
|