10.7. Pressure accumulator
Prevention
Gasoline extremely fire - is also explosive therefore it is necessary to show care during the work on any part of fuel system.
Works on fuel system need to be performed in well aired room for what it is possible to open all windows and doors for draft creation.
During the work on fuel system do not use naked flame, electric welding and tools during the work with which sparks can be formed. Check that in close proximity to a workplace there is a charged fire extinguisher.
For protection of eyes against hit of fuel in them use points. At hit of fuel on skin wash out this place a plentiful amount of water.
Capacity in which there was a fuel contains vapors of fuel and is potentially explosive.
During the work with fuel system observe purity as the dirt which got to canals of fuel system can block them that will break normal operation of the engine.
Removal
| PERFORMANCE ORDER |
| 1. The accumulator of pressure is installed in the giving fuel-supply line behind the fuel filter and is available from under the lower part of the car. |
| 2. Take off pressure in fuel system. |
| 3. Remove a weight wire from the accumulator. |
| 4. Lift a back part of the car and record on supports. |
| 5. Unscrew screws and remove the protection cover of the fuel pump, the fuel filter and the accumulator of pressure. |
| 6. Using clips, press fuel hoses from two parties of the accumulator of pressure. |
| 7. Disconnect all fuel-supply lines from pressure accumulator. If connection of bayonetny type is used, remove sealing laying. |
| 8. Unscrew screws, take a fixing belt and remove pressure accumulator from an arm. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is made in the sequence, the return to removal. |
| 2. Start the engine and check that there are no leaks from connections of the accumulator of pressure. |
|