12:14. Electronic anti-detonation ARA system
ELECTRONIC CONTROL UNIT
Removal
| PERFORMANCE ORDER |
| 1. On models with a pneumatic control system of idling turns, the electronic control unit of ARA is located in a back part of a motor compartment behind the partition false panel. |
| 2. Remove a weight wire from the accumulator. |
| 3. Disconnect the electric socket from an electronic control unit. |
| 4. Unscrew screws and remove the block from a partition of a motor compartment. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is made in the sequence, the return to removal. |
|
RPM METER OF THE BENT SHAFT
Removal
| PERFORMANCE ORDER |
| 1. Remove a weight wire from the accumulator. |
| 2. Disconnect the electric socket of the sensor of a bent shaft which is located in a motor compartment behind the accumulator. |
| 3. The sensor of a bent shaft is installed on the interfaced surface between the block of cylinders and a case of coupling over a starter. Unscrew a bolt and remove the sensor of a bent shaft from a coupling case. Remove laying. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is made in the sequence, the return to removal. |
|
SENSOR OF TEMPERATURE OF COOLING LIQUID
Removal
| PERFORMANCE ORDER |
| 1. Merge a part of cooling liquid from the cooling system. Check that ignition is switched off. |
| 2. The sensor of temperature of cooling liquid is located in the left top part of a head of the block of cylinders. |
| 3. Disconnect the electric socket from the sensor of temperature of cooling liquid. |
| 4. Unscrew the sensor and remove a sealing ring. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is made in the sequence, the return to removal. Add cooling liquid in the cooling system. |
|
ELECTROMAGNETIC EXECUTIVE MECHANISM
Removal
| PERFORMANCE ORDER |
| 1. The electromagnetic executive ARA mechanism is fixed by bolts on a back part of the fuel pump of high pressure. On the cars equipped with electronic control by turns of idling of ELR and an anti-detonation control system of ARA the electromagnetic executive mechanism is located below (see rice. Side view of a back part of the fuel pump of high pressure). |
| 2. Remove a weight wire from the accumulator. |
| 3. On models without turbo-supercharging remove the air filter. |
| 4. Disconnect the electric socket from the executive mechanism. |
| 5. Unscrew two bolts and remove the case of the executive mechanism from a back part of the fuel pump of high pressure. Remove a sealing ring and a pusher. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is made in the sequence, the return to removal. At installation of the executive mechanism establish a new sealing ring. At installation of the new executive mechanism remove a pusher from the old executive mechanism and install on the new executive mechanism. |
|