9.12. Inlet collector


1. Remove a weight wire from the accumulator.
2. Merge cooling liquid from the cooling system.
3. Remove the carburetor.
4. Remove a vacuum hose of the vacuum amplifier of brakes from an inlet collector.
5. Mark and remove hoses of system of ventilation of a case of the automatic transmission, the central blocking of locks and the valve of system of recirculation of exhaust gases from an inlet collector.
6. Weaken collars and remove hoses of cooling liquid from an inlet collector.
7. Disconnect the electric socket from a heater of an inlet collector, release wires from brackets and move them aside.
8. Unscrew nuts and remove an inlet collector from a head of the block of cylinders. Remove laying.


1. Being careful and using a plastic or wooden scraper, clear the interfaced surfaces of an inlet collector and a head of the block of cylinders.
2. Establish an inlet collector with new laying on a head of the block of cylinders.
3. Further installation is made in the sequence, the return to removal taking into account the next moments.
4. Tighten nuts of fastening of an inlet collector the required moment.
5. Fill in cooling liquid in the cooling system.
6. Connect the electric socket to a heater of an inlet collector.
7. Start the engine, check and, if necessary, adjust turns of idling and maintenance WITH in exhaust gases.