6.11.3. Installation

PERFORMANCE ORDER
1. Oil hydraulic pushers pure engine and establish them in nests of a head of the block of cylinders.
2. Establish a persistent half ring for adjustment of an axial side play of the camshaft.
3. Grease necks and cams of the camshaft with pure engine oil and install the camshaft in a head of the block of cylinders so that the groove on a forward flange was directed up.
4. Establish covers of bearings of the camshaft and tighten bolts of fastening of covers in the following sequence.

Four-cylinder engines

PERFORMANCE ORDER
1. In the diagonal sequence tighten bolts of fastening of covers of bearings No. 2 and 4, turning each bolt on a half of a turn for one pass until each cover does not concern a head of the block of cylinders. Then in the same sequence tighten bolts in several stages the required moment. Gradual and uniform tightening of bolts is necessary for uniform compression of springs of the valve.
2. Similarly tighten bolts of fastening of covers of bearings of the camshaft No. 1, 3 and 5.

Five-cylinder engines

PERFORMANCE ORDER
1. In the diagonal sequence tighten bolts of fastening of covers of bearings No. 3, 4 and 5, turning each bolt on a half of a turn for one pass until each cover does not concern a head of the block of cylinders. Then in the same sequence tighten bolts in several stages the required moment. Gradual and uniform tightening of bolts is necessary for uniform compression of springs of the valve.
2. Similarly tighten bolts of fastening of covers of bearings of the camshaft No. 1, 2 and 6.

Six-cylinder engines

PERFORMANCE ORDER
1. In the diagonal sequence tighten bolts of fastening of covers of bearings No. 2, 3, 4 and 7, turning each bolt on a half of a turn for one pass until each cover does not concern a head of the block of cylinders. Then in the same sequence tighten bolts in several stages the required moment. Gradual and uniform tightening of bolts is necessary for uniform compression of springs of the valve.
2. Similarly tighten bolts of fastening of covers of bearings of the camshaft No. 1, 5 and 6.
3. Establish camshaft asterisks.