| 1. Take a bent shaft from the block of cylinders. |
| 2. In the presence check that sprays of oil are installed in the block of cylinders. |
| 3. Clear a back part of an insert and the place of its installation in the block of cylinders and covers of radical bearings. Establish inserts on the places. |
4. Establish the top persistent half rings for adjustment of an axial side play of a bent shaft as follows:
– on 4-cylinder engines on the central radical bearing No. 3;
– on 5-cylinder engines on the radical bearing No. 4;
– on 6-cylinder engines on the radical bearing No. 5. |
| 5. Oil a working surface of inserts pure engine and install a bent shaft in the block of cylinders of the engine. |
| 6. Grease the lower inserts in covers of radical bearings with pure engine oil and check that ledges on inserts are in cover grooves. |
| 7. According to marking establish covers of radical bearings on the places. Check that persistent half rings are on the corresponding cover of the radical bearing. |
| 8. Grease bolts of fastening of covers of bearings of a bent shaft with pure engine oil, insert them into covers and tighten by hand. On 6-cylinder DOHC engines bolts of fastening of covers of radical bearings without carving openings under a bolt of a masloulavlivatel in a head are established from a driving chain. Before installation of bolts establish an arm of fastening of a maslozaborny tube. |
| 9. Gradually and in the diagonal sequence from the center to edge tighten bolts of fastening of covers of bearings in several stages (see rice. Tightening of a bolt of fastening of a cover of the radical bearing the required moment, Tightening of a bolt of fastening of a cover of the radical bearing a dovorachivaniye on a certain corner). |
| 10. Check that the bent shaft rotates smoothly and without jammings. |
| 11. Establish a new sealing ring in a back cover of a bent shaft, then install a cover with new laying or on a thin layer of sealant on the block of cylinders (see rice. Drawing a thin layer of sealant on the interfaced surface of a back cover of a bent shaft on 6-cylinder petrol DOHC engines, Tightening of bolts of fastening of a back cover of a bent shaft on 6-cylinder DOHC engines). |
| 12. Install pistons with rods. |
| 13. Further assembly is made in the sequence, the return dismantling taking into account the next moments. |
| 14. On 4-cylinder engines establish an asterisk of a bent shaft, a driving chain, a cover of a driving chain, the oil pallet and a flywheel / plate of the drive. |
| 15. On 6-cylinder petrol SOHC engines establish an asterisk of a bent shaft, a driving chain, the lower cover of a driving chain, the oil pump, the oil pallet and a flywheel / plate of the drive. |
| 16. On 6-cylinder petrol DOHC engines establish an asterisk of a bent shaft, a driving chain, the lower cover of a driving chain, the oil pump, a masloulavlivayushchy plate, the oil pallet and a flywheel / plate of the drive. |
| 17. On diesel engines establish an asterisk of a bent shaft, a driving chain, a cover of a driving chain, the oil pump, a masloulavlivayushchy plate, the oil pallet and a flywheel / plate of the drive. |