| 1. Oil cores of valves pure engine and insert them on the places. The valve establish on those places where they were ground in. |
| 2. Establish a spring nest. Lower a maslootrazhatelny cap in fresh engine oil and establish it on a valve core into place, being careful not to damage its working edges. For protection of working edges of a maslootrazhatelny cap before installation it is possible to wind with an adhesive tape a valve core end face. |
| 3. Establish a valvate spring and a plate of a spring. |
| 4. Special adaptation squeeze a valvate spring and establish crackers in dredging of a core of the valve and grease them. Remove the device for compression of a spring. Repeat this operation on other valves. |
| 5. Knock with the hammer through wooden whetstone on a valve core end face in order that all elements of the valve accurately were established on the places. |
| 6. Establish a thermostat casing on a head of the block of cylinders. |
| 7. Screw in glow plugs. |
| 8. Install the camshaft and the mechanism of the drive of valves with hydraulic pushers. |
| 9. Establish inlet and final collectors. |
| 10. Establish a head of the block of cylinders (you watch the corresponding description in subsection 6.12). |