| 1. Unscrew screws and uncover the carburetor shock-absorber together with a quencher of fluctuations of the piston (see rice. Removal of a cover of the shock-absorber of the carburetor together with a quencher of fluctuations of the piston). Remove from a cover a sealant ny laying. |
| 2. Unscrew screws and remove the shock-absorber from the piston case. At the same time keep in mind that one of these screws fixes the delay valve (see rice. Removal of the shock-absorber from the carburetor case, the Arrangement of the screw which also fixes the delay valve). |
| 3. Take a returnable spring of the piston, then in the form of the uniform block take the piston, a diaphragm and a needle of a jet from the carburetor case (see rice. Extraction of a returnable spring of the piston, Extraction in the form of the uniform block of the piston, a diaphragm and a needle of a jet). |
| 4. Check a condition of a diaphragm of the piston. If the diaphragm has defects in the form of cracks or through openings, operation of the carburetor will be broken. Replace a diaphragm for what, holding the piston, unscrew screws of fastening of a diaphragm, remove a washer and a diaphragm from the piston (see rice. Arrangement of screws of fastening of a diaphragm of the piston). |
| 5. Install on the piston a new diaphragm so that the ledge from a reverse side of a diaphragm was combined with dredging on the surface of the piston. |
| 6. Establish a washer on a diaphragm and fix by screws. |
| 7. Install the block of the piston, a diaphragm and needle of a jet in the carburetor case so that the ledge on an external edge of a diaphragm was combined with dredging on the carburetor case (see rice. Combination of a ledge on an external edge of a diaphragm with dredging on the carburetor case). Check that the air opening on the basis of the piston is from the engine. |
8. Establish a returnable spring of the piston, then the shock-absorber and fix by screws, considering that one of screws fixes the delay valve.
Prevention
For a diaphragm shift exception at installation do not rotate the shock-absorber. Establish a cover амортизато ра with a quencher of fluctuations of the piston with new laying and fix by screws.
|
| 9. Unscrew a jellied stopper with амортизато ра and add in the shock-absorber the required oil so that the level of oil was below the basis of an opening of a jellied stopper. Screw in a jellied stopper into place. |