23:15. Lower lever of a back suspension bracket

Removal

Unscrewing of the nut fixing an earring of the stabilizer of cross resistance to the lower lever of a back suspension bracket

PERFORMANCE ORDER
1. Lift a back part of the car and record on supports. Remove the corresponding back wheel.
2. Unscrew screws and remove the protection cover from the basis of the lower lever.
3. Using special adaptation, squeeze a spring so that it departed from the top part. When using special device for compression of springs you watch that rounds of a spring were reliably taken and you make compression of a spring from the opposite sides. The spring has very big effort of compression therefore use only very reliable tool. Do not connect a spring by a wire at all.
4. Unscrew a nut and take the bolt fixing an earring of the stabilizer of cross resistance to the lower lever (see the drawing).
5. Support by a jack through wooden whetstone the lower lever of a back suspension bracket.
6. Unscrew a nut and take a bolt of fastening of the lower part of the shock-absorber.
7. Unscrew a nut and take an external hinged bolt of fastening of the lower lever. Being careful, lower the lower lever of a back suspension bracket and remove a cylindrical spring with the top basic cup.
8. Unscrew a nut, then take an internal hinged bolt of fastening of the lower lever of a back suspension bracket and remove the lever.

Repair

PERFORMANCE ORDER
1. Clear the lower lever of a back suspension bracket of dirt and an anticorrosive covering and check it for existence of cracks or mechanical damages. Pay special attention to plugs of fastening of the lever. If it is necessary to make replacement of plugs, this work needs to be performed at service station as application of a hydraulic press and the corresponding mandrels for this purpose is required.

Installation

PERFORMANCE ORDER
1. Install the lower lever of a back suspension bracket into place, insert an internal hinged bolt and a washer and screw a new nut, without tightening it it is final.
2. Check that the lower basic cup of a spring pure, then install the top basic cup on a spring and establish a spring into place.
3. Turn a cylindrical spring so that its lower end correctly settled down in the lower nest of a spring. Install the top basic cup of a spring under fastening and, being careful, lift the lower lever of a back suspension bracket so that it was combined with the nave fastener, an earring of the stabilizer of cross stability and the shock-absorber.
4. Check correctness of placement of a spring, then insert an external hinged bolt of fastening of the lower lever, screw on it a new nut, but do not tighten finally.
5. Combine the lower end of the shock-absorber with the lever, insert a bolt of fastening and screw on it a new nut, without tightening it it is final.
6. Insert a bolt of fastening of an earring of the stabilizer of cross stability, then screw a new nut on a bolt, without tightening it it is final.
7. Establish a back wheel, then lower the car on the earth and tighten bolts of fastening of a wheel the required moment.
8. Shake the car in order that all elements of a back suspension bracket rose on the places. Tighten all nuts on bolts the required moment. Install the protection cover on the basis of the lower lever and screw it screws.