23.19.3. Pressure accumulator

Removal

Places of connection of a tube and pressure head hose (1) to the accumulator of pressure and an arrangement of bolts of fastening (2) accumulators of pressure

PERFORMANCE ORDER
1. Take off pressure in hydraulic system.
2. Wipe area about connection of the accumulator of pressure and lay rags in order that it was possible to collect the spilled liquid. Unscrew a connecting bolt, the fixing pressure head hose of the shock-absorber to the top part of the accumulator of pressure, and remove laying. Unscrew a connecting nut and pick up the phone from pressure accumulator connecting pressure accumulator to the control unit (see the drawing).
3. Unscrew the nuts fixing pressure accumulator to the car bottom.
4. For access to the top bolt of fastening remove backs of back sitting, then unscrew screws and remove a forward part of a covering of half of the luggage compartment. For access to back screws of fastening remove the panel from half of the luggage compartment. Now it is possible to remove pressure accumulator from the car.

Installation

PERFORMANCE ORDER
1. Install the accumulator of pressure upon the place, then screw new nuts of fastening and tighten them the required moment.
2. Connect a hose and a tube to pressure accumulator. At the same time from two parties of the connecting coupling of a hose establish laying and fix them by a nut and a bolt, having tightened them the required moment.
3. Install the panel on half of the luggage compartment and fix by screws.
4. Fill hydraulic system with liquid.